ABB PST30 Installation And Commissioning Manual page 37

Figure 1: Package
1SFC132003M0201
Chapter 4 Mounting
This chapter describes instructions on how to receive the
softstarter and how to mount it in a proper way.
4:1 Receiving, unpacking and checking
• Check that the package is turned with the correct side up,
figure 1.
• Check for transport damages.
• Remove the transport casing.
• Visually inspect the softstarter.
• Check that the serial number corresponds with the deliv-
ery documents.
• Check that all items are included, according to the deliv-
ery note.
• Check the softstarter as well as the package. If you find
any damages, please contact the transport company or
the supplier immediately.
4:1.1 Intermediate storage
Until the softstarter is mounted it should be stored in its
package.
4:2 Mounting
4:2.1 Handling when mounting
The softstarter is available in five physical sizes. The models
PST30 to PST300 can be taken out of the packages and be
mounted without lifting equipment.
For mounting of models PSTB370 to PSTB1050, lifting
equipment is recommended due to the weight.
See Chapter 3 "Description", for weights.
Warning!
Do not lift the softstarter in the connection bars, since it
may cause damage to the product.
Chapter 4
Mounting
37