Table of Contents
Advertisement
12.7 Operation
L240/BS
The operation of the wall reader is undertaken by the insertion of electronic
chip keys and/or by entering a 6-digit keypad code.
Important: If an incorrect entry is made, it is necessary to wait for longer
than six seconds before the next entry is made.
Chip key:
The chip key is inserted into the reader slot on the wall reader and
immediately retracted. It is irrelevant which side of the key points
upwards as it is a reversible key.
After five invalid chip key insertions (chip key not created in the
Evaluation Module L240/BS), a time inhibit of five minutes occurs.
During this inhibit time, neither a valid keypad code nor valid chip key
will be accepted. Commencement of a triggered inhibit time will be
indicated by a short signal tone.
Each valid or invalid insertion of chip keys is logged in the access log
with date, time and XIB address of the corresponding evaluation
module.
Keypad code:
Each button push on the wall reader is confirmed by a beeping tone.
Only 6-digit keypad codes are permissible. If an incorrect entry is made,
the "STOP" button must be pushed and the 6-digit code must be re-
entered.
After five invalid keypad entries (keypad not added to the Evaluation
Module L240/BS), a time inhibit of five minutes occurs. During this
inhibit time neither a valid keypad code nor valid chip key will be
accepted. Commencement of a triggered inhibit time will be indicated by
a short signal tone.
Each valid or invalid keypad entry is logged in the access log with date,
time and XIB address of the corresponding evaluation module.
91
Advertisement
Table of Contents
