Table of Contents
Advertisement
7.1.7
Menu 7 "Remote"
Engineer-PIN
1 = Time/Date
2 = Tamp.Reset
3 = Test
4 = Change PIN
5 = Printer
6 = Service
7 = Remote
8 = Edit
9 = Cct Off
Submenu
"01=Connection"
Submenu
"02=Operations"
Submenu
"03=Auth Code"
Operation by the Engineer
Menu item "7=Remote" VdS: Communication between the panel and a
PC/Laptop can occur (e.g. programming using software). Different
parameters must be set for this purpose.
01=Connection
02=Operations
03=Auth Code
04=SiteID
05=Panel-IP *
06=Panel-Port *
07=Gateway IP *
08=Subnet Mask *
09=GSR 1 S/N *
10=GSR 2 S/N *
11=GSR 3 S/N *
12=GSR 4 S/N *
In submenu "01=Connection" the type of connection is set.
Connection
Off/On-Off
Connection
Type-Serial
If "Serial" is selected, the transfer speed must also be selected, so that it
corresponds with the setting on the PC:
Connection
Baud-9600
In submenu "02=Operations" the "Auto" parameter should be selected.
Thereafter the permitted authorization levels for the user with existing
communication must be selected and can be accepted directly.
Operations
Enable-Off
In submenu "03=Auth Code" an enable code can be entered. As the
enable occurs without code, this function is not relevant and no entries must
be made.
Auth Code
Auth Code-000
* Menus only appear if the
Type=Ethernet has been
selected.
Enter: 0=OFF; 1=ON
Enter: 1=Serial; 2=Ethernet
Enter: 1=9600; 2=4800... (Help button)
Press button 2
41
Advertisement
Table of Contents
