Table of Contents
Advertisement
Configuration and Programming by the Engineer
8.1.6
Menu 06 "Keypads"
Engineer-PIN
8 = Edit
01 = System Size
02 = Area Opts
03 = Circuits
04 = Relay
05 = Alarm Times
06 = Keypads
07 = Concs *
08 = User Auth
09 = Text
10 = L240/B/BS*
11 = XS/1.1 KNX *
13 = 2-Conc Tamper *
15 = Defaults
16 = XIB-Detectors
8.1.7
Menu 07 "Concs"
Engineer-PIN
8 = Edit
01 = System Size
02 = Area Opts
03 = Circuits
04 = Relay
05 = Alarm Times
06 = Keypads
07 = Concs *
08 = User Auth
09 = Text
10 = L240/B/BS*
11 = XS/1.1 KNX *
13 = 2-Conc Tamper *
15 = Defaults
16 = XIB-Detectors
Menu item "06=Keypads": Enable or disable of different operating features
on the keypad. The service keypad (address 0; connected to the internal
bus) cannot be programmed.
Menu item "07=Concs": The circuit modules L240/MG2 and L840/MG4 are
assigned to area 1 after logon. In this menu, the other areas can be
assigned.
The supplementary Power Supply Unit L240/N is treated in the same way as
a Detector Circuit Module L840/MG4, i.e. in menu 01 "Hardware" (chapter
8.1.1) it is counted as a circuit module and is also addressed in this way on
the DIP switches.
After selection of the menu the following request appears:
Concentrator
Number _
Concentrator-01
Area-1
If the stated circuit module number is a battery, the battery capacity must be
entered.
If for example, 2 x SAK7 are connected, the following must be set:
Concentrator-01
Bat.1 (Ah)-07
Concentrator-01
Bat.2 (Ah)-07
Address of the circuit module
Area of the circuit module
(factory default 00)
(factory default 00)
60
Advertisement
Table of Contents
