Tow Bar Assembly - Toro GreensPro 1200 Service Manual

Tow Bar Assembly

Removal
(Figure 76.)
3
2
1
14
24
1. Ball joint 6. Flat washer
2. Nut 7. Ball joint
3. Lifting bar 8. Bushing
4. Nut 9. Axle clamp (4 pairs used)
5. Cap screw 10. Flat washer (2 used)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
2. Raise machine (transport wheels down and locked).
Chock the transport wheels and support front and rear
of the machine to prevent it from shifting.
3. Support the tow bar (12).
4. Remove nut (11), flat washer (10), cap screw (5),
GreensPro 1200
5
6
7
8
4
9
13
14
14
14
24
Figure 76
11. Nut (2 used)
12. Tow bar
13. Axle clamp plate (8 used)
14. Heavy flat washer (16 used)
15. Tow bar clamp screw (8 used)
Page 5 - 39
12
14
13
10
11
9
11
10
9
13
22
23
16. Bushing
17. Ball joint (LH threads)
18. Flat washer
19. Cap screw
20. Nut (LH threads)
flat washer (6), and bushing (8), and disconnect lifting
bar (3) from tow bar (12).
5. Remove nut (11), flat washer (10), cap screw (19),
flat washer (18), and bushing (16), and disconnect
lifting bar (21) from tow bar (12).
6. Lower the tow bar (12) to the ground.
15
14
13
14
13
9
14
13
16
17
18
19
20
21
21. Lifting bar
22. Nut
23. Ball joint
24. Nut (8 used)
Chassis