Drive Roller Assembly - Toro GreensPro 1200 Service Manual

Drive Roller Assembly

Removal
(Figures 60 through 65.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from the spark plug.
2. Using a suitable lifting device, raise and support the
machine.
3. Remove transmission cover from machine (see
Transmission Cover in this section).
1
8
7
6
Figure 60
4. Remove nut (4) and flat washer (5).
5. Remove lock nut (1), two flat washers (2), cap screw
(7), flat washer (8), and spacer (3), and remove drive
chain tension assembly (6).
Chassis
2
3
5 4
6. Remove retaining ring (9).
7. Remove two set screws (10).
Page 5 - 28
9
Figure 61
10
Figure 62
GreensPro 1200