Steering Disc Assembly - Toro GreensPro 1200 Service Manual

Steering Disc Assembly

NOTE: Refer to illustration of steering control assembly
(Figure 37) in this section when removing and servicing
the steering linkage assemblies.
Removal
(Figures 45 through 47.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
2. Using a suitable lifting device, raise and support the
machine.
1
4
Figure 45
3. Remove front linkage arm (1), rear linkage arm (4),
and steering pivot rod (3) from steering disc assembly
(2) (see Steering Linkages in this section).
2
8
Figure 46
4. While supporting steering disc assembly (2) to
prevent it from falling, remove lock nut (6) and plated
washer (7). Then remove steering disc assembly (2)
and steering spacer bushing (5) from chassis (8).
Chassis
2
3
5
6 7
8
5. Remove cap screw (9) and flat washer (10) from
chassis (8).
6. If necessary, remove pivot bushing and two Oilite®
bushings from steering disc (2).
Page 5 - 22
9 10
Figure 47
GreensPro 1200