Steering Rollers - Toro GreensPro 1200 Service Manual

Steering Rollers

Disassembly and Assembly
(Figure 59.)
1
2
3
11
1
2
3
7
1. Lock nut (2 used per roller assembly)
2. Bearing (4 used per roller assembly)
3. Bearing housing (4 used per roller assembly)
4. Short steering roller
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
2. Remove steering rollers from steering head
assembly. (See Steering Head Assembly in this
section.)
3. Remove and replace parts as necessary to repair
the steering rollers.
GreensPro 1200
4
5
3
2
6
2
10
10
8
3
2
6
2
3
Figure 59
5. Roller spacer
6. Short roller spacer
7. Long steering roller (3 used)
8. Long roller spacer (3 used)
Page 5 - 27
3
7
8
3
2
10
7
8
3
2
9. Short steering axle
10. Long steering roller assembly (3 used)
11. Short steering roller assembly
12. Long steering axle
4. The bearing housing (3) is pressed into the steering
roller, and the bearing (2) is pressed into the bearing
housing. If bearing or bearing housing is removed from
steering roller, make sure that new components are
pressed fully into the roller during installation.
5. When installing lock nuts (1), tighten nuts equally on
both ends of the roller to allow free rotation of the
rollers. Do not overtighten lock nuts.
6. Install steering rollers in steering head assembly.
(See Steering Head Assembly in this section.)
9
1
1
12
Chassis