Oil Filter Assembly - Toro GreensPro 1200 Service Manual

Oil Filter Assembly

Removal
(Figures 24 and 25.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from the spark plug.
2. Move motion pedals to relieve system pressure.
3. Remove transmission cover from machine (see
Transmission Cover in the Service and Repairs section
of Chapter 5 - Chassis).
4. Drain oil from oil tank into a suitable container.
5. Thoroughly clean hose end and fittings on the oil
filter assembly to prevent oil system contamination.
2 3
1
6
Figure 24
6. Label all hoses and fittings for assembly purposes.
Remove hoses (1 and 5) from fittings on oil filter
assembly. Drain hoses into a suitable container.
7. Put clean plugs in disconnected hoses and fittings
to prevent system contamination.
8. Remove two cap screws (2), lock washers (3), and
flat washers (4), and remove oil filter assembly (6).
GreensPro 1200
4
5
Page 4 - 19
7
Figure 25
9. Remove two straight fittings (7) from oil filter
assembly (8).
8
7
Hydraulic System