Toro GreensPro 1200 Service Manual page 35

7 8
15 16
14
12
13
Figure 11
6. Install idler arm assembly (13) using cap screw (14),
flat washer (12), pivot bushing (15), two Oilite
bushings (16), spacer (9), flat washer (7), and nut (8).
7. Install flat washer (11) and nut (10).
NOTE: If additional chain tension adjustment is
needed, nuts on tension rod can both be installed on
side of frame bracket that is closest to machine
centerline.
NOTE: If the drive chain tension assembly requires
service, see Drive Chain Tension Assembly in this
section.
15 16 17
Figure 12
8. Install cap screw (15), lock nut (16), and two flat
washers (17) at the bottom of the transmission.
GreensPro 1200
9
10
11
®
Page 4 - 11
Figure 13
9. Connect transmission collar to drive coupling using
two lock nuts (18), two washers (19), two cap screws
(20), and four bushings (21).
IMPORTANT: To prevent drive coupling damage,
make sure that no distortion of coupling exists
after securing engine collar to coupling. If coupling
distortion is evident, loosen transmission and
reposition transmission on frame so that coupling
is not distorted. If necessary, engine can be
loosened and repositioned to reduce distortion of
the coupling.
22
28
25
Figure 14
10.Connect linkage arm (27) using cap screw (28),
bushing (26), lock nut (24), and two flat washers (25).
11. Connect damper (22) using nut (23).
18 19 20 21
23
24 25
26
27
Hydraulic System