Four Slot Battery Charger Installation; Wiring - Motorola WT4070 Integrator Manual

Four Slot Battery Charger Installation

The Four Slot Spare Battery Charger has four mounting slots on the back. Around the slots are guides that assist in
proper alignment of the charger onto the mounting bracket. Gravity holds the charger in place.
Installing the Battery Charger onto the Mounting Bracket
Figure 2-15
Position the charger over the mounting studs and slide the charger into place.
Ensure that the charger is seated properly.

Wiring

The AC line cord provides AC power to the power supply. The mounting bracket power cable provides power from
the power supply to the Four Slot Ethernet cradle and the Four Slot Spare Battery Charger. Ethernet cables (not
supplied) connects the cradle to the local network and to another cradle, if required.
Ensure that the AC line cord is long enough to reach from the AC power source to the power supply.
Route the AC line cord through the right cable slot of the bracket.
1.
Plug the AC line cord into the power supply AC input connector.
2.
Route the power supply connector of the power cable through the cradle channel and out the left side of the
3.
cradle.
Plug the power cable connector into the DC output connector on the power supply.
4.
Plug the cradle power plug into the Four Slot Ethernet cradle input power connector.
5.
Plug the charger power plug onto the Four Slot Spare battery Charger input power connector.
6.
Plug one end of the Ethernet cable into the appropriate connector on the Four Slot Ethernet cradle.
7.
Route the cables as shown in
8.
Use two tie-wraps to secure the power cable Y connection to the power supply mounting shelf.
9.
Mounting Studs
Figure 2-16 and Figure
Mounting Slots
2-17.
Accessories 2 - 17