Voice Only Wt4090 - Motorola WT4070 Integrator Manual

Select the
12. Image Files To Load
In the Comm Port drop-down list, select
13.
Click to begin the operation.
14. Download
During download, the
15.
When complete,
16. Device Status
On completion, press
17.
To exit IPL, select the
18.

Voice Only WT4090

Press the P1 and P2 keys and Power button.
1.
The Voice Only WT4090 performs a cold boot.
2.
Press the P2 key. The three LEDs turn on indicating that the Voice Only WT4090 is in IPL mode.
3.
On the development computer, click
4.
Load Terminal Window - Serial and Ethernet Tabs
Figure 7-15
To insure a successful download, do not remove power from the Voice Only WT4090 while in IPL mode.
CAUTION
NOTE The hex images must be downloaded in the following order:
1. Monitor (Voice Only WT4090 resets after downloading monitor)
2. Config Block
3. Partition Table and Power Micro
4. Platform, Splash Screen, Application and Windows CE.
If the platform or application partition sizes are changed, you must download a new partition table first.
Select the
5. Image Files To Load
In the Comm Port drop-down list, select
6.
Click to begin the operation.
7. Download
indicate the progress of the download. When 33% is completed the first LED turns on, followed by second LED when 66%
is completed and finally the third LED when 100% of the download. Depending on the size of each image the time taken to
indicate this progress may vary.
.
USB: Symbol Device
screen on wearable terminal displays the
Downloading
displays
Result was: Success!
to return to the IPL menu to select the next partition to download.
ENTER
item from the IPL menu (see
System Reset
on the TCM toolbar. The
Load
.
USB: Symbol Device
As soon as the download starts, all three LEDs turn on and then the three LEDs
Application Deployment 7 - 15
.
Device Status
, or in the case of an error, the cause of the error.
Figure 7-9 on page 7-11).
window >
Load Terminal
.
and a progress bar.
tab appears.
Serial