Draytek Vigor2960 Series User Manual page 320

Route/NAT Mode
Source IP
Apply NAT Policy
Netbios Naming
Packet
Apply
Cancel
5. After filling the required information for Advanced, click the GRE tab to open the
following page.
Available parameters are listed as follows:
Item
Enable GRE
Function
alive.
If the remote network only allows you to dial in with single
IP, please choose this mode, otherwise please choose Route
Mode.
Choose one of the LAN profiles as a source IP.
Enable – This option allows for performing one-to-one NAT
for all traffic flowing across the VPN.
Translated Local Network – Specify the IP address with
subnet mask of the network that all traffic will be translated
into.
Enable – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.
Disable –When there is conflict occurred between the hosts
on both sides of VPN Tunnel in connecting, such function
can block data transmission of Netbios Naming Packet inside
the tunnel.
Click it to save the configuration.
Click it to exit the page without saving the configuration.
Description
Click Enable to enable such function.
312
Vigor2960 Series User's Guide