Draytek Vigor2960 Series User Manual page 102

Specify Remote
Dial-in IP
Gateway IP
Address
More Subnet
DNS Redirection
IPv6 Protocol
Add – Click it to add a new DHCP option profile.
Save – Click it to save the setting.
DHCP Option – Use the drop down list to choose the one
you want.
Value – Type the content of the data to be processed by the
function of DHCP option.
Enable – Check the box to enable this function. Remote
clients within the range specified below can access into
Vigor2960 WUI.
Type a public gateway address for such WAN profile.
Different subnets can be created under one LAN profile.
Specify other subnets which might be needed in the future.
Add – Click it to add a new subnet mask with IP address and
specified mode.
Save – Click it to save the settings.
IP – Type the IP address if you click Add for adding a new
entry.
Subnet Mask – Use the drop down list to choose the one you
want.
Mode – Specify NAT or Routing as the mode.
DHCP – Click Enable to activate the DHCP function on such
subnet. When it is enabled, you have to specify the IP range
to be assigned by the DHCP server for such subnet.
Start IP – Type an IP address as a starting point.
End IP – Type an IP address as an ending point.
Enable – It can redirect DNS queries from such LAN profile
to router's DNS Server. It must work with LAN DNS
function.
It defines the IPv6 connection types for LAN interface.
Possible types contain Link-Local, Static and DHCP-SLA.
Except Link-Local, each type requires different parameter
settings.
94
Vigor2960 Series User's Guide