Exterior Parts Removal/Installation - Honda Accord 2008 Body Repair Manual

Main Menu
General Information

Exterior Parts Removal/Installation

NOTE:
To adjust the alignment of the hood, the doors, and the tailgate, refer to the Accord Service Manual.
●
When adjusting the door in or out, replace the mounting bolts (A) (90102-SFA-305).
●
Apply spot sealer to the mating surface, then install the front fender, hood, doors, and hinges.
●
6 x 1.0 mm
18 N·m
(1.8 kgf·m,
13 lbf·ft)
HOOD HINGE
6 x 1.0 mm
18 N·m
(1.8 kgf·m, 13 lbf·ft)
FRONT FENDER
1-12
Table of Contents
TRUNK LID HINGE
HOOD
6 x 1.0 mm
18 N·m
(1.8 kgf·m, 13 lbf·ft)
UPPER FRONT
DOOR HINGE
LOWER FRONT
DOOR HINGE
(A) 8 x 1.25 mm
29 N·m (3.0 kgf·m, 22 lbf·ft)
6 x 1.0 mm
18 N·m (1.8 kgf·m, 13 lbf·ft)
TRUNK LID
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
FUEL FILL DOOR
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
UPPER REAR
DOOR HINGE
LOWER REAR
DOOR HINGE
(A) 8 x 1.25 mm
29 N·m
(3.0 kgf·m, 22 lbf·ft)
FRONT DOOR
8 x 1.25 mm
29 N·m (3.0 kgf·m, 22 lbf·ft)
REAR DOOR
TORX BOLT
8 x 1.25 mm
29 N·m
(3.0 kgf·m, 22 lbf·ft)