Table of Contents
Advertisement
Installing an App on an IP Camera
If you have not yet enabled app support for the camera, a dialog box appears that says "Application
support is not enabled on this camera. You are redirected to Configuration window where you can enable
application support on camera."
If the Application support dialog box appears, take these actions:
Step 2
a.
b.
c.
d.
e.
f.
Step 3
Click Browse in the Application Installation area and navigate to the app package that you want to
install.
The app file must have the extension .cpk.
Step 4
Select the app file and click Open.
Step 5
Click the Install button in the Application Installation area.
A dialog box informs you when the application is installed.
Configuring an App
After you install an app on an IP camera, you must configure its operation.
To configure the operation of an app on an IP camera follow these steps:
Procedure
From the IP camera user interface, click the Setup link, click Application Manager to expend the menu,
Step 1
then click App Setup.
Click the radio button for the app that you want to configure.
Step 2
Click the Configure button.
Step 3
In the window that appears, make configuration settings as needed and click the Save button.
Step 4
For detailed information about configuration settings for a particular app, see Cisco IP Camera Apps
Reference Guide.
Configuring Event Triggering
This section describes how to enable event triggering on an IP camera, which allows apps that support
triggers to cause the camera to take certain actions when an event occurs.
To enable the triggering of actions by apps that support triggers, follow these steps:
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
6-6
Click OK to display the Configuration window.
In the Configuration window, check the Enable Application check box.
(Optional) Check the Enable Video check box and choose a resolution from the Resolution
drop-down list if you will run applications that use the video features of the camera.
(Optional) Check the Enable Audio check box if you will run applications that use the audio
features of the camera.
Click Save.
Choose App Setup from the Application Manager drawer.
Chapter 6
Application Manager
OL-32285-01
Advertisement
Table of Contents
