Local Storage - Cisco Video Surveillance 3000 Series Configuration Manual

Local Storage

Table 4-8
Option
HTTP Authentication
Email Notification Area
SMTP Server
SMTP Port
POP Server
Authentication
Account Name
Password
Password
Send To
Show From Address As Enter the e-mail address to be shown in the From field for the e-mail message
Subject
Local Storage
The Local Storage window allows you to enable storing video on a local storage device in case of a
network loss. You can download these video recordings from the Local Storage window.
When you use local storage, be aware of the following:
•
•
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
4-26
Alert Notification Window Options (continued)
Description
If authentication is required on the primary server to which HTTP messages
are sent, choose the authentication method from the drop-down list.
Identify the SMTP server that is used for sending e-mail by choosing IP
Address or Hostname from the drop-down list and entering the IP address
or host name in the corresponding field.
Enter the port number for the SMTP server. The default SMTP port number
is 25.
Identify the POP server that is used for sending e-mail by choosing IP
Address or Hostname from the drop-down list and entering the IP address
or host name in the corresponding field.
This field is dimmed if you do not choose Requires POP Before SMTP in
the Authentication field that follows.
If the SMTP server requires authentication to send e-mail, choose the
appropriate authentication type from the drop-down list. The authentication
type typically is the same as that for the POP3 server that you use to receive
e-mail.
If the SMTP server requires authentication, enter the account name for the
server.
If the SMTP server requires authentication, enter the account password for
the server.
If the secondary SMTP server requires authentication, enter the account
password for the server.
Enter an e-mail address to which an e-mail message is sent when an event
occurs.
that is sent when an event occurs.
Enter the text to be shown in the Subject field for the e-mail messages that
the IP camera sends when events occur. The subject can contain up to 118
characters, including spaces.
You can configure the IP camera to save all recordings (continuous recording mode) to the SD or
MicroSD card, or to save only recording that are made when the IP camera looses network
connectivity (network loss mode).
The IP camera supports an SD or MicroSD card with a maximum storage capacity of 32 GB. For
efficiency and performance of the local storage feature, Cisco recommends that you use a SD or
MicroSD card with a storage capacity of 32 GB.
Chapter 4 Feature Setup
OL-32285-01