Cisco Video Surveillance 3000 Series Configuration Manual page 52

Local Storage
The Local Storage window appears. If you change any options in this window, you must click the Save
button to save the changes. If you do not click this button, changes are not retained when you exit the
window. The Save button appears at the bottom of the window. You might need to scroll down to it.
Table 4-9
To use the features in the Recordings area, ActiveX must be installed on your client PC. If ActiveX is
Note
not installed, the Recordings area displays a message with this information. To install ActiveX, From the
window IP camera web-based interface that instructs you to install the Cisco Camera UI Control , click
Install in the yellow banner. If a Security Warning dialog box appears, click Install.
To prevent corruption to data on an SD or MicroSD card or the inability of the IP camera to detect the
Caution
card again, before removing an SD or MicroSD card from an IP camera, stop recording to the card and
use the Unmount button (described in
when inserting, removing, and handling the card to avoid damaging the card.
Table 4-9
Option
SD/MicroSD Information Area
Serial Number
Total Size
Free Space
Model
Manufacturer
Mount/Unmount
(toggle button)
Format
Settings Area
Enable recording to
Local Storage on
network loss
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
4-28
describes the options in the Local Storage window.
Local Storage Window Options
Description
Display only. Serial number of the SD or MicroSD card that is installed in
the IP camera.
Display only. Total storage capacity in megabytes of the SD or MicroSD
card.
Display only. Free storage space in megabytes of the SD or MicroSD card.
Display only. Model number of the SD or MicroSD card.
Display only. Manufacturer of the SD or MicroSD card.
Mount button—When you insert an SD or MicroSD card, the IP camera
typically mounts it automatically. If you see a message that indicates that the
card is not mounted, click this button to mount it.
Unmount button—Click on this button to prepare an SD or MicroSD card for
ejection from the IP camera.
Formats an SD or MicroSD card.
Use this button to format a card if you switch recording modes or switch the
video stream configuration.
This options causes the IP camera to save video recordings to its local SD or
MicroSD card if the IP camera looses network connectivity. When the
network connectivity is restored, recording to the card stops.
This option and the Enable continuous recording option cannot be enabled
at the same time.
Table 4-9 ) to prepare the card for ejection. In addition, use care
Chapter 4 Feature Setup
OL-32285-01