Table of Contents
Advertisement
DIAGNOSTICS & TROUBLESHOOTING
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
DISPLAY FAULT/ERROR CODES
The error codes below would be indicated when
DISPLAY
PF
E1
E2
E3
E4
E5
E6
ELECTRIC DRYERS
Electrical Shock Hazard
DESCRIPTION
EXPLANATION AND RECOMMENDED PROCEDURE
PF flashes to indicate that a power failure occurred
while the dryer was running. Press Start to continue
POWER
the cycle, or press Pause/Cancel to clear the display.
FAILURE
Refer to TEST #1.
E1 flashes in the numeric display when the
TEMPERATURE
temperature sensing circuit is open.
SENSOR OPEN
Refer to TEST #3a.
E2 flashes in the numeric display when the
TEMPERATURE
temperature sensing circuit is shorted.
SENSOR
SHORTED
Refer to TEST #3a.
If during a cycle the blower rotational speed drops
BLOWER
below 500 rpms, all outputs will be turned off and
ROTATION
error code E3 will be displayed.
FAILURE
Refer to Diagnostics Tests, Diag Test #2.
If during a cycle the tumbler rotational speed drops to
TUMBLER
0, all outputs will be turned off and error code E4 will
ROTATION
be displayed.
FAILURE
Refer to Diagnostics Tests, Diag Test #2.
If during a Dry Rack cycle the signal is lost, all outputs
DRY RACK
are turned off and E5 is displayed.
SENSOR
Refer to TEST #8.
If the exhaust temperature goes above 190°F (87.7°C)
EXHAUST
all outputs will turn off and E6 will be displayed.
HIGH LIMIT
FAULT
Refer to TEST #3b.
WARNING
attempting to start a drying cycle, or after acti-
vating the Diagnostic Test mode.
6-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
