Removing The User Interface, The Control Board, And The Door Sensor - KitchenAid Pro Line KHEV01RSS Technical Education

REMOVING THE USER INTERFACE, THE
CONTROL BOARD, AND THE DOOR SENSOR
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Pull the dryer away from the wall far enough
to access the back.
4. Lift and remove the rubber mat from the
top of the dryer.
Rubber Mat
5. Remove the four T-20 screws from the rear
of the dryer top cover. Do not remove the
two Phillips screws and spacers.
2 Phillips Screws
Do Not Remove
4 Top Cover Screws
Lift & Remove
4-2
6. To remove the top cover, pull the cover
back, align the pins with the keyhole slots
in the side panels, and lift the cover off
the dryer.
Top Cover
Remove Pins From Keyhole Slots
7. Remove the two Phillips screws from the
rear of the control panel. NOTE: The screws
are captured and cannot be removed from
the chassis.
2 Control Panel Screws
8. Lift the control panel, pull the bottom two
pins from their keyhole slots, and rotate the
panel down, as shown. Be careful not to
scratch the panel.
2 Control Panel Pins
Lift
Pull