Accessing & Removing The Electronic Assemblies - KitchenAid Pro Line KHEV01RSS Technical Education

ACCESSING & REMOVING THE
ELECTRONIC ASSEMBLIES
There are two electronic assemblies; the user
interface assembly, and the machine control
electronics. See Figure 7.
1. Unplug dryer or disconnect power.
2. After removing the top panel, remove the
console screws located in the upper cor-
ners of the console. See Figure 7.
User Interface Assembly
Figure 7. Locate the electronic assemblies
3. Slide the console so that the console pins
located at the bottom corners of the con-
sole move up and out from the slots, re-
moving the console from the front of the
machine. See Figure 8.
Figure 8. Slide console pins up and out of slots
Machine Control Electronics
4. Disconnect the door switch cable from
the control board and disconnect the UI
(User Interface) cable from the UI. Also
cut the cable tie holding the UI cable to
the console. See Figure 9.
Cable Tie
Hold Down Tab
Figure 9. Disconnect cables to remove user interface
assembly from console
Removing the User Interface Assembly
5. Remove the hold down tabs. See Figure 9.
6. Remove the user interface assembly.
Removing the Machine Control
Electronics Assembly
5. Referring to Figure 10, loosen the 4
screws for cover, then slide cover to the
right and out from the machine control
board.
Machine Control
Figure 10. Accessing the machine control electronics
6-28
User Interface Assembly
Door Switch
Cable
User Interface Cable
Machine Control Board
Screw Locations