KitchenAid Pro Line KHEV01RSS Technical Education page 35

2. Place drying rack inside dryer drum, po-
sitioning the back wire on the ledge of the
inner dryer back panel. Push down on
front feet of drying rack, at the same time,
aligning the locator tabs with the locator
indentations in the dryer drum.
A
B
A. Dryer back panel
B. Locator tabs
C. Locator indentations (inside dryer drum)
3. Put the wet items on top of the rack. Leave
space between the items so air can reach
all the surfaces.
NOTE: Do not allow items to hang over the
edge of the rack.
4. Close the door.
5. Select Dry Rack cycle. Items containing
foam, rubber or plastic must be dried on
a clothesline or by using the Air Only tem-
perature setting.
C
3-7
6. You must select a time by pressing the
MANUAL DRY TIME (- or +) buttons. Reset
time as needed to complete drying. Refer
to the following table.
7. Press and hold START button (about 3 sec-
onds).
NOTE: You must remove rack for normal tum-
bling.
This chart shows examples of items that can
be rack dried and the suggested temperature
setting and drying time. Actual drying time
will depend on the amount of moisture items
hold.
Rack Dry
Wool Sweaters
Block to shape and lay flat on
the rack
Stuffed toys or pillows
Cotton or polyester fiber filled
Stuffed toys or pillows
Foam rubber filled
Sneakers or canvas shoes
*(Minutes) Reset time to complete drying, if needed.
Temp. Time*
Low 60
Low 60
Air Only 90
(no
heat)
Air Only 90
(no
heat)