Connect Vent; Level Dryer; Complete Installation - KitchenAid Pro Line KHEV01RSS Technical Education

CONNECT VENT

1. Using a 4˝ (10.2 cm) clamp, connect vent
to exhaust outlet in dryer. If connecting to
existing vent, make sure the vent is clean.
The dryer vent must fit over the dryer ex-
haust outlet and inside the exhaust hood.
Make sure the vent is secured to exhaust
hood with a 4˝ (10.2 cm) clamp.
2. Move dryer into its final position. Do not
crush or kink vent.
3. (On gas models) Check that there are no
kinks in the flexible gas line.
ATTACH DECORATIVE MAT
(OPTIONAL)
1. Locate the 2 holes in the back of your dryer.
Back view of dryer
2. Place the flat washer and then the spacer
on the mounting screw and attach to the
dryer using a Phillips screwdriver.
3. Check that the top of the dryer and the
bottom of the mat are clean.
4. Set the mat in place on top of the dryer.
Hook the back edge of the decorative mat
over the mounting screws.

LEVEL DRYER

All four dryer feet were preset to the same
height at the factory.
1. Using a 9/16˝ (14 mm) open-end wrench,
verify that the nuts on the two rear preset
feet are tightened against the cabinet.
2. Slide the dryer to its final location.
3. Check the levelness of the dryer. Check
levelness first side to side, then front to
back.
4. If the dryer is not level, move the dryer
slightly away from the wall and first prop
the front with a wood block and adjust the
feet as necessary; then prop the back and
adjust feet as necessary. Repeat this step
until dryer is level.
5. After the dryer is level, use a 9/16˝ (14 mm)
open-end wrench to turn the nuts on the feet
tightly against the dryer cabinet.

COMPLETE INSTALLATION

1. Check that all parts are now installed. If
there is an extra part, go back through the
steps to see which step was skipped.
2. Check that you have all of your tools.
3. Check the dryer's final location. Be sure
the vent is not crushed or kinked.
4. Check that the dryer is level. See "Level
Dryer."
5. Plug in dryer or reconnect power.
6. Remove any protective film or tape re-
maining on the dryer.
7. Dispose of/recycle all packaging materials.
8. Read "Dryer Use," page 3-1.
9. Wipe the dryer drum interior thoroughly
with a damp cloth to remove any dust.
2-19