Yamaha HTR-5750 Owner's Manual page 64

Problem Cause
Remedy
The sound suddenly
The protection circuitry has been acti'ated
[heck that the impedance selector setting is correct.
goes oft because
of a short circuit.
etc.
Check that the speaker wires are not touching each
other and then turn this unit back on.
The Mem) timer has turned the unit oft
Turn en the power. and play the source again.
Eh,: sound is. nutted
Press MUTE to cancel a mute.
Only the speaker on Incontet
cable connections
( onnect theeables properly. It the problem persists.
one side can be
I
\ hc delectim
heard.
Incorrect halance settings in SET MENU
A s ljtis the SP I IA El. settings.
Only the center When playing a monaural source with a
speaker outputs CINEMA DSP program. the mitir,:e signal
substantial sound. is dueeted to the centm channel. and the
-
--
front and surround speakers output
eff
ect
sounds.
No sound from the The sound held programs are turned oil Press STRAIGIIT (EFFECT) to turn them on
effect speakers.
You arc using a source or program
Try another sound held program
combination that does not output sound
from all channels.
No sound from the The output level of the center speaker is Rai,: the le% el ol the center speaker.
center speaker. set to
"CENTER - in MIT MEM Hs set to Select the appropriate setting for the center speaker.
NONE.
()tie of the IliTi DSP programs (except
Try tamale' sound field program.
for 6ch Stereo) has been selected.
No sound from the
The output le .el
of the :51.ntound speaker , Raise the output level of the surround speakers.
surround speakers.
is set to minimum.
"SURR
I.R"
in SET MENU is set to
Select the appropriate setting for the suround left and 46
NONE. net
veakers.
A monaural SOLO ce is being played with
Pies,
STRAIGHT (EFFECT) to turn on the sound
STRAIGHT. Fields
No sound from the "SURR IR in
syr
MENU is set to It the sumound left and right speakers are set to
46
surround back NONE.
NO NI. the surround back speaker setting is
speaker.
automaticall set to NONE. Select the appropriate
setting for the surround speakers.
"SURR13 - in SET MEM I is set to
Select LEG or SW_
46
NONE.
No sound from the
subwooler.
"BASS OUT - in SET MENU is set to
FRONT
when a Dolby
Digital or DTS
signal is being played.
--
BASS OUT in SET MENU. is set to
SW112
or I - RNE when a 2-channel source
is being played.
The source.
does
not contain low bass
Select
S \SFR or BOTH
Select BOTH.
46
46
Refer to
page
20
26
II
47
31
27.39
47
46
27.39
47
60