Yamaha HTR-5750 Owner's Manual page 15

5
Tighten the knob to secure the wire.
•
Banana plug connections
(With the exception of U.K. and Europe models)
First, tighten the knob and then insert the banana plug
connector into the end of the corresponding terminal.
Banana plug
(With the exception of U.K. and
Europe models)
Speaker connections
Be sure to connect the left channel (I.). right channel 112).
(red) and - us (Hack) properly. If the connections are
faulty. no sound will he heard from the speakers. and if the
polarity of the speaker connections is incorrect, the sound
wiII be unnatural and lack bass.
If you
will
use 6 ohm speakers, be sure to set
this unit's speaker impedance setting to 6
ohms before using (see page 20).
Before connecting the speakers. make sure that the
power of this unit is off.
Do not let the bare speaker wires touch each other or do
not let them touch any metal part of this unit.
This
could damage this unit and/or speakers.
Use magnetically shielded speakers. If this type of
speakers still creates the interference with the monitor.
place the speakers away from the
monitor.
A speaker cord is actually a pair of insulated cables
running side by side. One cable i
s colored or shaped
differently, perhaps with a
stripe, groove or ridges.
Connect the striped (grooved, etc.) cable to the "+- (red)
terminals on this unit and your speaker. Connect the plain
cable to the --- (black) terminals.
10 mm (3/81
1
H
2
II
1 Remove approximately 10 mm (318") of
insulation from the end of each speaker
cable.
2
Twist the exposed wires of the cable together
to prevent short circuits.
3
Unscrew the knob.
4
Insert one bare wire into the hole in the side
of each terminal.
11