Honda 2006 Accord Owner's Manual page 463

05/10/03 20:26:01 32SEA630_463
Wiper Blades
WIPER BLADE
3. Remove the blade from the blade
assembly:
Find the side of the blade
labelled ''LOCK.'' This is the
side you pull out.
Pull back the end of the blade
assembly on the ''LOCK'' side of
the blade. Then grad the end of
the blade, and slide it out.
460
Maintenance
REINFORCEMENT
STRIP
4. Examine the new wiper blades. If
they have no plastic or metal rein-
forcement along the back edge,
remove the metal reinforcement
strips from the old wiper blade and
install them in the slots along the
edge of the new blade.
5. Install the new blade onto the
blade assembly:
Pull back either end of the blade
assembly.
Place the side of the blade not
labelled ''LOCK'' on the end of
the blade assembly, and slide
the blade onto the assembly
until it is fully installed.
6. Slide the wiper blade assembly
onto the wiper arm. Make sure it
locks in place.
7. Reinstall the cover.
8. Make sure the blade is completely
installed and that its edge is not
bunched up.
9. Lower the wiper arm down against
the windscreen, the passenger's
side first, then the driver's side.