Digicom 2000 User Manual page 6

CHAPTER_.2A_ 4/8/00 11:19 PM
2–5
Page 6
Inserting an Overlay
Following the instructions, insert a 4x8
Programmer's Overlay with blank squares
(message keys) on it. This overlay has 12 function
keys labeled across the top row and four more
rows of 8 keys each which are blank.
By putting this overlay in, you can set up the
DigiCom and begin recording so you can
practice basic operations.
Placing An Overlay on the DigiCom
❑ Locate the appropriate Programmer's Overlay
(in practice example, 4x8)
❑ Lift the protective sheet of plastic by placing
your fingers near the top of the keyboard and
lifting up to release the magnetic hold.
❑ Remove any overlay that might be there,
place a new overlay over the touch panel.
Be sure and center the overlay so it is seated
on the touch panel.
❑ Lower the protective sheet and secure it.
The magnetic strips will hold the protective
plastic cover and overlay in place.
(cont.)