Digicom 2000 User Manual page 15

CHAPTER_.2A_ 4/8/00 11:19 PM
PROGRAM/ AREA/ PLAYING IMMEDIATE/ KEYBOARD
LOCK
PLAY SEQUENCE TIME LINK LAYOUT
SPEAK LEVEL DEFINE RECORD LINK BACKSPACE
AUTOSPEAK EDIT
ERASE
SEQUENCE SEQUENCE
PROGRAM/ AREA/ PLAYING IMMEDIATE/ KEYBOARD
LOCK
PLAY SEQUENCE TIME LINK LAYOUT
SPEAK LEVEL DEFINE RECORD LINK BACKSPACE
AUTOSPEAK EDIT
ERASE
SEQUENCE SEQUENCE
Page 15
Using the Correct System
SET UP
Mode: Program or Play
OK
The DigiCom has two system modes of operation:
HOLDTIME SCAN
SET UP COMMAND
VOLUME VOLUME
STOP REMOVE DOWN UP
Program and Play. It is important to know when to
< > OK CANCEL
DISK TRANSFER
use each mode. When a user is `speaking' with
the DigiCom, it should be in Play mode. When
PROGRAM/
PLAY
you are programming, it must be in Program
SPEAK
mode. If you have been following along, you
SPEECH
CONTROLS
have already experienced a bit of programming
HOLDTIME SCAN
SET UP COMMAND
VOLUME VOLUME
using Program mode.
STOP REMOVE DOWN UP
< > OK CANCEL
DISK TRANSFER
System Mode: Program
To begin any programming into the DigiCom
you must put it into Program mode. You
cannot record, adjust the sleep time, or perform
other functions unless you are in Program Mode.
Program Mode will be used primarily by
programmers and people helping the DigiCom
augmentative communicator.
To enter Program mode, follow these steps:
1. Press [SET UP].
2. Press [Program/Play]. (It is the first gold colored
function key on left.)
3. If the display shows:
4. Press [<] or [>] and the display will show:
5. Press [OK].
When the DigiCom is in Program mode, you will
have access to all its functions. You will learn
about these functions throughout the next few
chapters.
Mode: PLAY
< > OK Cancel
Mode: PROGRAM
< > OK Cancel
2–14