Digicom 2000 User Manual page 32

CHAPTER_.2A_ 4/8/00 11:19 PM
2–31
Page 32
Scanning
Using the scanning mode, a switch or a joystick
can be used to play back messages rather than
the touchpanel. See Chapter Six, Scanning, for
set up and use of scanning.
Programming Exercise 1
Now that you have learned about the equipment
and some fundamentals about programming the
DigiCom, see if you can follow the exercise below
to record your name into the unit. And, as you do
this exercise, think through what you are doing so
you can learn additional skills more easily as you
progress in this manual.
1.) Place a 4x8 programmers overlay on the
DigiCom touch panel.
2.) Plug the unit in if the battery is low.
3.) Turn the DigiCom "on".
4.) Check to see you are in Group A: System
Mode: Program
5.) Check to be certain the Keyboard Layout
matches the current overlay on DigiCom.
6.) Press [Record] (notice this is a white key so
you do not need to press any other key in
sequence.)
7.) The LCD displays the message:
Press and Hold a
Key to Rec. Upon
*rec. is an abbreviation for "record"