Digicom 2000 User Manual page 20

CHAPTER_.2A_ 4/8/00 11:19 PM
PROGRAM/ AREA/ PLAYING IMMEDIATE/ KEYBOARD
LOCK HOLDTIME
PLAY SEQUENCE TIME LINK LAYOUT
SPEAK LEVEL DEFINE RECORD LINK BACKSPACE STOP REMOVE
AUTOSPEAK EDIT
ERASE DISK TRANSFER
SEQUENCE SEQUENCE
PROGRAM/ AREA/ PLAYING IMMEDIATE/ KEYBOARD
LOCK HOLDTIME
PLAY SEQUENCE TIME LINK LAYOUT
SPEAK LEVEL DEFINE RECORD LINK BACKSPACE STOP
AUTOSPEAK EDIT
ERASE DISK TRANSFER
SEQUENCE SEQUENCE
2–19
Page 20
Lock Groups: Lock in Groups
SET UP
To Lock a User into a Group:
OK
1. Make sure the DigiCom is in Program mode.
2. Press [SET UP] and then [Lock Groups].
SCAN
SET UP COMMAND
VOLUME VOLUME
DOWN UP
< > OK CANCEL
3. The display will show:
LOCK
GROUPS
GROUP
4. Press [OK] to go to the next item. The display
will show:
SCAN
SET UP COMMAND
VOLUME VOLUME
REMOVE DOWN UP
< > OK CANCEL
you have 7 options:
NONE or Groups A, B, C, D, E, F
if you do not want to lock into a group, always
select NONE. (DigiCom is shipped with NONE as
the default setting for Lock Group.)
5. Press the [<] or [>] key to select a group to stay
on and then press [OK]. Once you have made
your decision,
6. Press [OK]. The display will return to:
* where – shows the Group you selected
7. After locking into a group and changing to Play
mode, [Group] key is disabled so the user is
forced to stay in that Group. While in Program
mode, you will continue to have access to all
groups. (This is an important distinction to
remember!)
8. To Lock in: NONE, return to Program mode and
press [Setup] and [Lock Groups] again. Repeat
the above sequence and select `NONE' or
another group.
9. The user again has access to all six groups in
Play mode.
Lock in Groups
< > OK Cancel
Lock in:
< > OK Cancel
GROUP _: PROGRAM
LEVEL 1: Areas
(cont.)