Digicom 2000 User Manual page 12

CHAPTER_.2A_ 4/8/00 11:19 PM
2–11
Page 12
Turning the DigiCom On
To turn the DigiCom "on" when it is "off",
press the Reset button on the right side panel.
Remember, the button is recessed to prevent
it from being pushed accidentally. You will
need to push the button with a pen or some
other narrow object. When the DigiCom
turns on the LCD display will quickly show:
DigiCom
Version X.XX
and
Starting
DigiCom...
and
GROUP A:PROGRAM
LEVEL1 Areas
where XX.XX is the software version such as
`Version 1.00'.
It will then be ready to use. If it was previously
programmed, all message and setting files will be
intact. Most electronic devices have two states,
`on' and `off'. The DigiCom has three states: on,
off, and sleep. [Note: `Sleep' is a resting state in
which the DigiCom appears to be `off' but is
actually in a low power state with all functions
ready and waiting. When your DigiCom first
arrived, it was off.]
If the DigiCom is in sleep state, you can `wake' it
up by simply pressing any key. When the DigiCom
`wakes' up, it is ready to be used immediately.