Digicom 2000 User Manual page 16

CHAPTER_.2A_ 4/8/00 11:19 PM
PROGRAM/ AREA/ PLAYING IMMEDIATE/ KEYBOARD
LOCK HOLDTIME
PLAY SEQUENCE TIME LINK LAYOUT
SPEAK LEVEL DEFINE RECORD LINK BACKSPACE STOP
AUTOSPEAK EDIT
ERASE DISK
SEQUENCE SEQUENCE
PROGRAM/ AREA/ PLAYING IMMEDIATE/ KEYBOARD
LOCK HOLDTIME
PLAY SEQUENCE TIME LINK LAYOUT
SPEAK LEVEL DEFINE RECORD LINK BACKSPACE STOP
AUTOSPEAK EDIT
ERASE DISK
SEQUENCE SEQUENCE
2–15
Page 16
If the DigiCom responds differently than you
would expect when you try to use the SET UP and
function keys, repeat your steps and read
carefully the messages shown in the LCD. If you
do not see what is described in this handbook,
refer to the troubleshooting chapter or call
technical support for assistance.
System Mode: Play
SET UP
Play mode is intended for use by the person who
OK
is `speaking' with the DigiCom. In most instances,
this person should not have access to Program
SCAN
SET UP COMMAND
VOLUME VOLUME
REMOVE DOWN UP
Mode.
< > OK CANCEL
TRANSFER
In Play mode, all of the message keys are active.
PROGRAM/
PLAY
However, only the following user function keys are
SPEAK
available: Speak, Level, Link, Backspace, Stop,
SPEECH
CONTROLS
Group, Volume Down, and Volume Up. This is to
prevent the user from accidentally changing the
SCAN
SET UP COMMAND
VOLUME VOLUME
REMOVE DOWN UP
< > OK CANCEL
TRANSFER
DigiCom settings or erasing the message files that
have been recorded.
To enter Play mode, follow these steps:
1. Press [SET UP].
2. Press [Program/Play].
3. If the display shows:
4. Press [<] or [>] and the display will then show:
5. Press [OK].
< HAVING TROUBLE?
Mode: PROGRAM
< > OK Cancel
Mode: PLAY
< > OK Cancel