Digicom 2000 User Manual page 13

CHAPTER_.2A_ 4/8/00 11:19 PM
PROGRAM/ AREA/ PLAYING IMMEDIATE/ KEYBOARD
LOCK HOLDTIME
PLAY SEQUENCE TIME LINK LAYOUT
SPEAK LEVEL DEFINE RECORD LINK BACKSPACE STOP
AUTOSPEAK EDIT
ERASE DISK
SEQUENCE SEQUENCE
PROGRAM/ AREA/ PLAYING IMMEDIATE/ KEYBOARD
LOCK HOLDTIME
PLAY SEQUENCE TIME LINK LAYOUT
SPEAK LEVEL DEFINE RECORD LINK BACKSPACE
AUTOSPEAK EDIT
ERASE
SEQUENCE SEQUENCE
Page 13
If the DigiCom will not turn on, don't panic. The
most likely problem is that the battery has drained.
Plug in the charger and then push the Reset but-
ton. If the DigiCom still doesn't turn on, refer to
Chapter Eight, Trouble Shooting.
Turning the DigiCom Off
The DigiCom will go into `sleep' state
automatically when not in use. This will conserve
battery power yet allow DigiCom to be ready for
use. However, there are times when the DigiCom
should be completely switched off, such as for
distance transporting.
To turn off the DigiCom, it must first be in
PROGRAM mode.
SET UP
Follow these steps to put the DigiCom into
OK
PROGRAM mode. (You will learn more about
PROGRAM mode later.)
SCAN
SET UP COMMAND
VOLUME VOLUME
REMOVE DOWN UP
< > OK CANCEL
TRANSFER
1. Press the gold function key labeled [SET UP].
PROGRAM/
2. Press [PROGRAM/PLAY].
PLAY
SPEAK
3. Press the [>] key to change the SYSTEM MODE
SPEECH
CONTROLS
to "PROGRAM". (Note: If it is already in
program mode, you can skip these steps.)
SCAN
SET UP COMMAND
VOLUME VOLUME
STOP REMOVE DOWN UP
< > OK CANCEL
DISK TRANSFER
4. Press [OK] to confirm your selection.
< HAVING TROUBLE?
2–12