Are You Sure - Digicom 2000 User Manual

CHAPTER_.2A_ 4/8/00 11:19 PM Page 27
Lock Levels: Lock out Levels
10. Now, in both Program and Play modes, the
user does not have access to those levels
locked out. The [Level] key will beep but will
not change status beyond the levels you
made available.
11. To have full access to all the levels, return
to Program mode and press [SET UP and
Lock Levels] again and select `NONE'.
12. The user now has access to all eight levels.
Erase a Level
Because the DigiCom automatically erases a
level as you change methods (Areas, Picture
Sequence, Spell Sequence) or the keyboard
layout is altered, it is seldom necessary to
manually erase a level. However, if you ever wish
to erase a level manually, follow the steps below.
1. Make sure the DigiCom is in Program mode.
Be certain you are in the desired Group on
which you want to erase a level.
2. Press [Level] until the level which you wish to
erase is visible on the display.
3. Press [Command] and then [Erase Level] to
erase a level. The display will prompt you:
4. Press [OK] to erase the level or [Cancel] to
leave it intact.
5. Press [OK] to confirm or [Cancel] to leave it
intact.
6. If you erase it, that level will return to the
default setting: 4x8 Areas.
Erase Level?
OK Cancel

ARE YOU SURE?

OK Cancel
(cont.)
2–26