Honda EP3 Service Manual page 147

Gylinder Head
Cylinder Head Gover Installation (cont'd)
Set the spark plug seals (A) on the spark plug tubes.
O n c e t h e c y l i n d e r h e a d c o v e r ( B ) i s o n t h e c y l i n d e r
head, slide the cover slightly back and forth to seat
the head cover gasket.
Inspect the cover washers (C). Replace any washer
that is damaged or deteriorated.
6-42
7. Tighten the bolts in two or three steps. In the final
s t e p , t i g h t e n a l l b o l t s , i n s e q u e n c e , t o 9 . 8 N . m ( 1 . 0
kgf.m, 7.2 lbf.ft).
8 . I n s t a l l t h e d i p s t i c k ( A ) a n d b r e a t h e r h o s e i B ) .
\
\ l