Door Position Adiustment - Honda EP3 Service Manual

Doors
Door Glass Adiustment {cont'd)
6. Raise the glass fully, and check for gaps. Check that
the glass (A) contacts the glass run channel (B)
evenrv.
7 . Check for water leaks. Run water over the roof and
on the sealing area as shown, and note these items:
. U s e a 1 2 m m ( 1 / 2 i n . ) d i a m e t e r h o s e ( A ) .
. Adjust the rate of water flow as shown {B).
. Do not use a nozzle.
. H o l d t h e h o s e a b o u t 3 0 0 m m ( 1 2 i n . ) a w a y f r o m
the door (C).
12mm1112in,l
!
\ e
Attach the plastic cover, and installthe door panel
(see page 20-4).
9. Test-drive and check for wind noise.
300 mm {12 in.l
20-12
Door Position Adiustment
\
NOTE; Check for equal gaps between the front, rear,
and bottom door edges and the body. Check that the
door and body edges are parallel.
1. Place the vehicle on a firm, level surface when
adjusting the door.
2. Adjust at the hinges {A):
. Remove the front inner fender (see page 20-102)
and front fender fairing (see page 20-103).
Loosen the hinge mounting bolts (B) slightly, and
move the door backward or forward, uD or down
as necessary to equalize the gaps.
. Place a shop towel (C) on the jack (D) to prevent
damage to the door when adjusting the door.
t ,
8 x 1 . 2 5 m m
29 N.m (3.0 kgf.m,
22 tbt.trl
\