Congestion Control Configuration; Configuring The Congestion Control Threshold; Configuring Service Congestion Policies - Cisco ASR 5000 Series 3G Home NodeB Administration Manual

▀ Congestion Control Configuration

Congestion Control Configuration
To configure Congestion Control functionality:
Step 1
Configure Congestion Control Threshold by applying the example configuration in the Configuring the Congestion
Control Threshold section.
Step 2 Configure Service Congestion Policies by applying the example configuration in the Configuring Service Congestion
Policies section.
Step 3
Optional. Operator can configure the system to reject all new incoming calls to specific or all HNB-GW service
instance in a busy-out or planned maintenance or for troubleshooting by applying the example configuration in the
Configuring New Call Policy section.
Step 4
Save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode
command
save configuration
System Administration Guide and the Command Line Interface Reference.

Configuring the Congestion Control Threshold

To configure congestion control threshold, apply the following example configuration:
configure
congestion-control threshold max-sessions-per-service-utilization <percent>
congestion-control threshold tolerance <percent>
end
Notes:
 There are several additional threshold parameters. See the Global Configuration Mode chapter of the Command
Line Interface Reference for more information.
 The tolerance is the percentage under a configured threshold that dictates the point at which the condition is
cleared.
 Repeat this configuration as needed for additional thresholds.

Configuring Service Congestion Policies

To create a congestion control policy, apply the following example configuration:
configure
congestion-control policy hnbgw-service action { drop | none | reject }
end
Notes:
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
94
. For additional information on how to verify and save configuration files, refer to the
HNB-GW Service Configuration Procedures
OL-25069-03