Rtp Ip Pool Configuration Verification - Cisco ASR 5000 Series 3G Home NodeB Administration Manual

HNB-GW Service Configuration Procedures
 For more information on commands/keywords that configure additional parameters and options, refer
command section in Context Configuration Mode Commands chapter of Command Line Interface Reference.

RTP IP Pool Configuration Verification

Step 1 Verify that your IPv4 address pool configured properly by entering the following command in Exec Mode:
show ip pool
The output from this command will look similar to the sample shown below. In this example all IP pools
were configured in the
OL-25069-03
context.
isp1
context : isp1:
+-----Type: (P) - Public
| (S) - Static
|
|+----State: (G) - Good
||
||++--Priority: 0..10 (Highest (0) .. Lowest (10))
||||
||||+-Busyout: (B) - Busyout configured
|||||
|||||
vvvvv Pool Name Start Address
----- --------- --------------- --------------- ------ ------
PG00 ipsec 12.12.12.0
RG00 pool3 30.30.0.0
SG00 pool2 20.20.0.0
PG00 pool1 10.10.0.0
SG00 vpnpool 192.168.1.250
Total Pool Count: 5
(R) - Private
(E) - Resource
(D) - Pending Delete
Mask/End Address Used
255.255.255.0
255.255.0.0
255.255.0.0
255.255.0.0
192.168.1.254
Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide ▄
RTP Pool Configuration ▀
ip pool
(R)-Resizing
Avail
0 254
0 65534
10 65524
0 65534
0 5
73