Installing A Cisco Nexus 7010 Chassis; Preparing To Install The Device; Required Tools - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m

Installing a Cisco Nexus 7010 Chassis

This chapter describes how to install a new or relocated Cisco Nexus 7010 chassis in a rack or cabinet.
For information about installing a Cisco Nexus 7018 chassis, see
7018 Chassis."
chassis, see
This chapter includes the following sections:
•
•
•
•
•

Preparing to Install the Device

This section includes the following topics:
•
•
•
You must set up one four-post, 19-inch EIA rack or cabinet before you can install the Cisco Nexus 7010
Note
chassis. Make sure that you order the rack or cabinet and have it delivered before installing the chassis.

Required Tools

Before you install the Cisco Nexus 7010 chassis into a rack, make sure that you have the following tools
and equipment:
•
•
•
•
OL-18634-01
For information about installing power supply units in the Cisco Nexus 7000 Series
Chapter 4, "Installing Power Supply Units."
Preparing to Install the Device, page 2-1
Installing the Bottom-Support Rails on the Rack, page 2-3
Installing the Chassis, page 2-7
Grounding the Cisco Nexus 7010 Chassis, page 2-11
Installing and Formatting CompactFlash Cards, page 2-16
Required Tools, page 2-1
Installing a Four-Post Rack or Cabinet, page 2-2
Unpacking and Inspecting a New Device, page 2-3
Mechanical lift capable of lifting 550 lbs (250 kg)
No. 1 Phillips screwdriver with torque capability
3/16-inch flat-blade screwdriver
Crimping tool
C H A P T E R
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
2
Chapter 3, "Installing a Cisco Nexus
2-1