Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 194

Repacking the System Components
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Step 22 Place the smaller three-segment divider in the empty area above the power supply boxes as shown in
View B in
Step 23 Remove each of the two bottom-support rails from the rack or cabinet by loosening the six screws that
secure it to the vertical mounting rails on the rack or cabinet.
Step 24 Reassemble the accessory kit by placing the following components in the accessory kit box:
• Bottom-support rails (two) and mounting screws (20)
• Console connector cables and adapters
Ground lugs (do not include the ground cable) and mounting screws (two per lug)
•
Power cables (one or two for each power supply)
•
Place the accessory kit box on top of the cushion that is located on top of the chassis.
Step 25
If your system included the optional midframe doors or air filter, pack those items in their original
Step 26
shipping boxes and place the boxes on top of the power supply boxes.
Place one J-box half on the bottom pallet along two sides of the pallet as shown in View B of
Step 27
Place the other J-box half on the other two sides as shown in View B of
Step 28
Connect the two J-box pieces with six Corro-Clips (three on each seam) as shown in View B of
Step 29
Figure
Place the corrugated cardboard lid on top of the package as shown in View B of
Step 30
Place each of the four edge protectors on one of the top edges of the lid. See View C of
Step 31
Secure the package to the pallet using at least seven packing straps (three in one direction and four in
Step 32
the other direction) as shown in View C of
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
D-8
Figure D-3.
D-3.
Appendix D Repacking the Cisco Nexus 7000 Series Device for Shipment
Figure D-3.
Figure
Figure D-3.
Figure D-3.
Figure D-3.
OL-18634-01
D-3.