Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 65

Chapter 3 Installing a Cisco Nexus 7018 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 3-8
4
1
Lower cable management assembly
3 Position the assembly so that the two lower
hooks on the rack-mount bracket fit inside the
two holes on the assembly, and then slide the
assembly down so that it is held by the hooks.
Attach an upper cable management assembly (800-31342-01) onto the two hooks that protrude from the
Step 2
upper half of the left rack-mount bracket that is attached to the Cisco Nexus 7018 device chassis, and
loosely fasten the assembly to the chassis with four flat-head M4x10 screws as shown in
OL-18634-01
Attaching the Lower Left Cable Management Assembly to the Left Rack-Mount
Bracket
2
1
3
3
2
Left rack-mount bracket
4 Loosely fasten the assembly to the
rack-mount bracket with four M4x10 screws.
Do not tighten these screws.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing the Cable Management Assemblies
Figure 3-9.
3-15