Installing The Chassis - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Installing the Chassis

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
1
Step 2 Use a Phillips screwdriver to screw in six M6 x 19 mm or 12-24 x 3/4 in. Phillips screws on each end of
each rail (using a total of 24 screws for both brackets) as shown in
Figure 3-2
1
1

Installing the Chassis

This section describes how to install the chassis (transporting and elevating the chassis to the rack using
a mechanical lift, pushing it onto the rack, and then securing it to the rack).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-6
For the first and heaviest chassis installed in a
rack, position two bottom-support rails at the
lowest RU on the rack.
Attaching a Bottom-Support Rail to a Rack
2
1
Four sets of 6 M6 x 19 mm Phillips screws or
four sets of 6 12-24 x 3/4 in. Phillips screws
Chapter 3 Installing a Cisco Nexus 7018 Chassis
2 Allow at least 43.75 inches (111.1 cm)
(25 RU) for each Cisco Nexus 7018 system.
Figure 3-2.
2
1
2 Adjustable bottom-support rails (2)
1
OL-18634-01