Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 45

Chapter 2 Installing a Cisco Nexus 7010 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
1 NRTL listed 45-degree grounding lug
Use the crimping tool to crimp the lug to the grounding wire. Verify that the ground wire is securely
Step 3
attached to the ground lug by attempting to pull the wire out of the crimped lug.
Step 4 Remove the adhesive label from one of the two system grounding pads, and secure the grounding wire
lug to the grounding pad with two M4 screws.
the front side of the chassis.
grounding lug and the grounding wire do not interfere with other device hardware or rack equipment.
Figure 2-6
OL-18634-01
Figure 2-7 shows the location on the rear of the chassis. Ensure that the
Grounding Port on the Front of the Cisco Nexus 7010 Chassis
Grounding port
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Grounding the Cisco Nexus 7010 Chassis
2 Grounding cable with 0.75 in. of insulation stripped
from the end
Figure 2-6 shows the location of the grounding pads on
2-13