Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 146

Replacing a Supervisor Module
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Step 9 If you are removing the module from a Cisco Nexus 7010 chassis, rotate the module 90 degrees
counterclockwise so that it is horizontal and you can see its circuitry from above.
Step 10 Place the removed module on the antistatic mat or antistatic foam.
If the replacement supervisor is in a shipping box, prepare the module for installation by following these
Step 11
steps:
a. Open the shipping box for the module and remove the module from its antistatic wrapping.
b. If the plastic protector shown in
the back of the module. Keep the plastic protector and the other packing materials so that you can
easily ship the module at a later time.
Figure 8-2
To prevent ESD damage, avoid touching the electronic circuitry and prevent anything else from coming
Caution
in contact with the circuitry.
On the replacement module, rotate both of the ejector levers away from the front of the module.
Step 12
If you are inserting the module into a Cisco Nexus 7010 chassis, rotate the module 90 degrees clockwise.
Step 13
Align the module to the chassis guides for the vacated slot (slot 5 or 6 on the Cisco Nexus 7010 chassis
Step 14
or slot 9 or 10 on the Cisco Nexus 7018 chassis), and slide the module part way into the slot.
With one or both hands on the front of the module, push the module all the way into the slot until it seats
Step 15
on the midplane connector.
Simultaneously push both ejector levers inward until they come in contact with the face of the module.
Step 16
The module should be fully seated in the slot and the captive screws should be aligned with their holes
in the chassis. If there is another module to the right of the one that you are installing, the EMI gasket
should close the gap between the modules.
Screw in the two captive screws to the chassis and tighten them to 69 N m (8 in-lbs).
Step 17
Reconnect the console cable to the CONSOLE SERIAL PORT as explained in the
Step 18
Console" section on page
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
8-6
Figure 8-2
Removing the Plastic Protector from the Supervisor Module
5-2.
Chapter 8 Removal and Installation Procedures
is included with the module, remove it by pulling it past
"Connecting to the
OL-18634-01