Honeywell Dolphin 9900 User Manual page 87

Decode Section
The Decode section specifies decoder settings when using the decoder with ScanWedge.
ScanWedge Entry
AimerDuration
AimerDelay
AimerDurationALR
AimerDelayALR
DefaultEnabledSymbo
logies
EnablePrefixData
EnableSuffixData
Dolphin® Power Tools User's Guide
Description
The number of milliseconds the
scanner aimer is displayed, after the
trigger key has been pressed down,
before attempting to decode a
barcode.
The amount of time between scans
before the aimer turns on again.
The amount of time the aimer stays
on. This setting is for an ALR
decoder.
The amount of time between scans
before the aimer turns on again.
This setting is for an ALR decoder.
Specifies which symbologies should
be enabled before processing the
Symbologies section.
See Symbologies Section on page 5-
17.
Enables or disables all prefix data
received from the decoder after a
successful scan.
All prefix data is defined in the
Settings Section (see page 5-3).
Enables or disables all suffix data
received via decoder after a
successful scan.
All suffix data is defined in the
Settings Section (see page 5-3).
Default
Value
0
[Decode
begins
instantly.
]
500
2000
500
0
1
1
Rev A
8/6/08
Available Values
Enter times in 1/1000th of a
second.
0=Use internal list
1=All symbologies are disabled
initially. Enable specific
symbologies in the
Symbologies section.
2=All symbologies are enabled
initially. Disable specific
symbologies in the
Symbologies section.
0=Disabled
1=Enabled
0=Disabled
1=Enabled
5 - 9