Honeywell Dolphin 9900 User Manual page 45

C:\Program Files\Honeywell\Power Tools and Demos for WM 6.0\Device
Image\Converted Files\Upgrade X.
The X increases by one each time you run a batch conversion.
4. When you click OK, the conversion runs.
5. EZConfig Editor creates two folders inside the Upgrade X folder: Converted EXMs and Original
INIs.
Note: An Upgrade X folder with these two subfolders is created every time you run a conversion.
Upgrades do not save over each other.
6. Check each converted EXM file in EZConfig Editor.
Note: Even though conversion is complete, you have not yet upgraded your terminal! The old INI files remain in their
original location on the terminal.
Upgrading Dolphin Terminals
Once you approve of the converted EXM files, you must transfer them to the Dolphin terminals manually.
1. Delete the old INI files stored in the terminal.
2. Follow the steps for installing an upgrade on a Dolphin terminal (see
Terminal on page
Note: You want to install an upgrade to make sure that you have the latest versions of AutoInstall.exe,
Autorun.exe, and EZConfig Editor on the terminal.
3. Transfer the new converted EXM files to the terminal and say yes when you are asked to replace the
existing files.
4. Cold boot the terminal. The new, converted EXM files install during AutoInstall.
Dolphin® Power Tools User's Guide
1-8) but don't cold boot yet.
Rev A
8/6/08
Installing an Upgrade on the
2 - 29