Scanwedge.exm Sections - Honeywell Dolphin 9900 User Manual

Disabling ScanWedge
Navigate to the Power Tools Main Window
OR
Select Exit on the Command Bar Menu
Modifying the ScanWedge Configuration File
When ScanWedge is installed, a ScanWedge.exm file is inserted in the \IPSM folder. This file specifies
configuration parameters for ScanWedge and must be located in the \IPSM directory. Do not move
ScanWedge.exm!
Use EZConfig Editor on the workstation to modify ScanWedge.exm. For more information, see
with Open EXM Files

ScanWedge.exm Sections

Section Description
Settings Programs general settings for ScanWedge.
Comm Specifies how the serial (RS-232) port interfaces with ScanWedge.
Decode Specifies how the decoder/scanner interfaces with ScanWedge.
Centering Defines the centering window for scanning bar codes when ScanWedge is
interfacing with the decoder.
Formatting Defines data formatting functionality.
Symbologies Defines the symbologies that the scanner can decode and send to
ScanWedge.
VK Mapping Defines the virtual key sent to ScanWedge for any decoded ASCII character.
Basic Values
In each section, the following values apply (unless otherwise specified in the tables below):
0 = Disable
1 = Enable
5 - 2
(see page 1-2) and tap the ScanWedge icon again.
(page 5-1).
on page 2-7.
Rev A
8/6/08
Working
See Page
5-3
5-6
5-8
5-11
5-12
5-17
5-20
Dolphin® Power Tools User's Guide