Rasman Configuration File - Honeywell Dolphin 9900 User Manual

RASMan Configuration File

RASMan application settings are stored in the Settings section of \IPSM\RASMan.exm. Use
Editor (see page 2-2) to change the values in the RASMan.exm file.
Key
AudioNotification
AutoConnectOnDock
AutoConnectOnStart
up
Connectoid
CommandLine
CommandArgs
ConnectDelay
Debug
DisableActiveSync
Dolphin® Power Tools User's Guide
Description
Enable and disable audio
notifications on connecting and
disconnecting.
Connects and disconnects RASMan
when the terminal is docked and
removed from the communication
peripheral.
Controls the automatic connection
when RASMan is started.
Note: RASMan attempts to connect
only if the device is docked
and AC power is detected.
Indicates the connection RASMan
should use.
Command to execute on a
successful connection.
Command arguments for the
CommandLine setting.
Specifies the amount of time to wait
before establishing the PPP
connection after RASMan is
started.
Enables and disables the creation
of a debug log file.
Disables the ActiveSync connection
when RASMan is running.
Default
Value
1
1
1
`USB
Connectio
n
Empty
Empty
2000
0
1
Rev A
8/6/08
EZConfig
Available Values
0=Disable
1=Enable
0=Disabled; RASMan connection
must be launched manually
when the terminal is docked.
1=RASMan connects on an AC
power event.
2=RASMan connects on RS-232/
USB connection.
0=Disabled; the PPP connection
is not established when
RASMan is started.
1=Enabled; the PPP connection
is established when RASMAN
is started.
`USB Connection
`115200 Default
`19200 Default
`38400 Default
`57600 Default
Note: These values must be
typed in exactly as they
appear here.
Leave empty if no action is
required.
Leave empty if no action is
required.
Enter values in milliseconds.
0=Disabled; no log file
1=Enabled; Creates a log file of
RASMan activity in the
folder.
0=Disabled; ActiveSync runs
while RASMan is running.
1=Enabled; the ActiveSync
connection is disabled while
RASMan is running.
\IPSM
6 - 11