Table of Contents
Advertisement
N300 Wireless Router Model JWNR2000Tv3
2.
Click Add to add a wireless device to the wireless access control list.
The Wireless Card Access Setup screen opens and displays a list of currently active
wireless cards and their Ethernet MAC addresses.
3.
If the computer or device you want is in the Available Wireless Cards list, select that radio
button; otherwise, type a name and the MAC address.
You can usually find the MAC address on the bottom of the wireless device.
Tip:
You can copy and paste the MAC addresses from the Attached Devices
screen into the MAC Address field of this screen. First, use each wireless
computer to join the wireless network. The computer should then appear
in the Attached Devices screen.
4.
Click Add to add this wireless device to the Wireless Card Access List.
The screen changes back to the Wireless Card Access List screen.
5.
Add each computer or device that you want to allow to connect wirelessly.
6.
Select the Turn Access Control On check box.
7.
Click the Apply button.
Wireless Repeating Function (WDS)
You can configure the JWNR2000Tv3 router to be used as a wireless access point (AP),
which enables it to act as a wireless repeater. A wireless repeater connects to another
wireless router as a client where the network to which it connects becomes the ISP service.
Note:
If you use the wireless repeating function, select either WEP or
None as a security option in the Wireless Settings screen. The WEP
option displays only if you select the wireless mode Up to 54 Mbps in
the Wireless Settings screen.
67
Advertisement
Table of Contents
