NETGEAR JWNR2000v2 Installation Manual

Installation Guide
N300 Wireless Router
Package Contents:
Slide-on
Router Stand
Ethernet Cable
Power Adapter
Attach the STAND to the ROUTER:
1. Place the stand on a level surface.
2. Slide the router onto the stand.
Step 1:
Connect your modem.
Internet
CAUTION:
MAKE SURE YOUR MODEM IS
TURNED OFF OR UNPLUGGED
BEFORE STARTING THE
INSTALLATION.
N300 Wireless Router
Step 2:
Connect your router.
(not included)
DSL or Cable
DSL or Cable
Modem
Step 4:
Power on your modem.
Wait until your modem cycles on
(approximately 2 minutes).
Note: If you have a battery-backed modem,
press the reset button. In some cases, you may
need to remove, then re-insert, the battery to recycle
your modem.
WPS push button
(not included)
Ethernet cable
Power on/off
button
N300 Wireless Router
Step 5:
Power on your router.
Wait until the power
LED turns solid green.
Step 3:
Connect your computer.
Laptop or Desktop
Computer
Step 6:
Configure settings.
Open a browser, such as
Internet Explorer. If the web
page doesn't display, close
and re-open the browser to
http://www.routerlogin.net
in the address bar to complete
the setup.